Otherwise, we may configure a route that depends on the existence
of an address or another route, and may fail when lifetime of one
of them are already zero.
Hopefully fixes#28358.
This allows using it with CLEANUP_ARRAY(). For the 2 call sites
where we don't need to free the array, we do a regular for loop
calling json_variant_unref() instead.
When a static null address is requested, e.g. Address=0.0.0.0/24,
then the corresponding Address object owned by Network object has
null address, and previously it did not match any addresses already
assigne to the interface.
Let's search matching Address object when originally it is requested as
the null address.
Then, the address configured with requested as a null address will be
kept on reconfigure.
Fixes#26113.
Request may refer Address object owned by Link, but its broadcast
address or label may be updated by address_equalify(), hence these
fields cannot be used in the hash and compare functions.
Before this patch, if a network has multiple routers and one of them
provides a captive portal, then the portal was overwritten or cleared
when another RA from another router is received.
This makes captive portals managed in the similar way as DNS servers or
DNS domains. So now captive portal can safely handled even if a network
has multiple routers.
This allows the correct, gracious, error handling to follow up in the
ndisc handler. Otherwise, an internal error is assumed and the interface
disabled.
Fixes: 9747955d2d ("ndisc: parse RFC8910 captive portal ipv6ra option")
When we request an address that already exists and is under removing,
we need to wait for the address being removed. Otherwise, configuration
of a route whose preferred source is the address will fail.
Fixes#28009.
Replaces #28088.
From `ip-link(8)`:
> [no]ignore-df - enables/disables IPv4 DF
suppression on this tunnel. Normally datagrams
that exceed the MTU will be fragmented; the
presence of the DF flag inhibits this, resulting
instead in an ICMP Unreachable (Fragmentation
Required) message. Enabling this attribute causes
the DF flag to be ignored.
If this option is enabled for a GRE/GRETAP tunnel, the `DF` flag in the outer IP header
will not inherit the inner IP header's `DF` flag.
This is useful to transfer packets that exceed the MTU of the underlay
network.
This makes a bond or bridge interface in the degraded-carrier state but has a routable address
handled as routable operational state.
If the carrier is degraded but the address state is routable then the operational state should be
seen as routable and not degraded because that may be the case for bonds if some of the links are down,
but when that happens the bond as whole is still routable.
This also makes operational state to degraded if address state is degraded even if the link state is
degraded-carrier.
Fixes#22713.
DHCP clients often send their own hostname in option 12. It can be useful
to store it with the lease so it can be shown to a human to easily identify
which lease belongs to which device.
RFC: https://www.rfc-editor.org/rfc/rfc2132#section-3.14
Fixes a regression caused by ab3aed4a03.
I thought the commit does not cause any severe regression. However,
drivers for network interfaces may be loaded later. So, we should wait
if no network interface is found.
Fixes#27822.
The setting IPv6AcceptRA= is defaults to yes, hence, even if a .network
file for an interface has static IP address configuration, it may takes
few seconds for the interface being configured state, as NDisc for the
interface needs to be finished. That makes wait-online.service
needlessly slow. Typically, such delay is not necessary for statically
configured networks.
Let's make the required condition slightly relaxed; if a .network file
has static IP address configurations, then let's make the matching
interface enter the 'configured' state soon after the static addresses
configured on the interface.
Note, this does not change the default for IPv6AcceptRA=, hence, NDisc
still runs on interfaces by default. So, addresses, routes, DNS servers,
and so on based on RA will be assigned on interfaces later.
Strictly speaking, this breaks backward compatibility, but the previous
behavior is not clearly documented. If a user requested both static
IPv4 address and IPv6 SLAAC address configured before an interface being
entered to the 'configured' state, then '--ipv6' for wait-online can be
used. So, the behavior change should not cause severe regression.
Closes#27779.
Luca Boccassi
Yu Watanabe
Daan De Meyer
Susant Sahani
Ronan Pigott
Yuxiang Zhu
Henrik Holst
Rene Hollander