When ACL support is enabled, systemd-tmpfiles-setup service sets the following
ACL entries to the volatile system journal:
$ getfacl /run/log/journal/*/system.journal
getfacl: Removing leading '/' from absolute path names
# file: run/log/journal/xxx/system.journal
# owner: root
# group: systemd-journal
user::rwx
group::r--
group:wheel:r-x
group:adm:r-x
mask::r-x
other::---
This patch makes sure that the exec bit is not set anymore for the volatile
system journals.
Commit 82501b3fc added an early break when a terminal node is found to
incorrect place -- before setting c. This caused trie to be built that
does not correspond to what it points to in buffer, causing incorrect
deduplications:
# cat /etc/udev/rules.d/99-bug.rules
ENV{FOO}=="0"
ENV{xx0}=="BAR"
ENV{BAZ}=="00"
# udevadm test
* RULE /etc/udev/rules.d/99-bug.rules:1, token: 0, count: 2, label: ''
M ENV match 'FOO' '0'(plain)
* RULE /etc/udev/rules.d/99-bug.rules:2, token: 2, count: 2, label: ''
M ENV match 'xx0' 'BAR'(plain)
* RULE /etc/udev/rules.d/99-bug.rules:3, token: 4, count: 2, label: ''
M ENV match 'BAZ' 'x0'(plain)
* END
The addition of "xx0" following "0" will cause a trie like this to be
created:
c=\0
c=0 "0"
c=0 "xx0" <-- note the c is incorrect here, causing "00" to be
c=O "FOO" deduplicated to it
c=R "BAR"
This in effect caused the usb_modeswitch rule for Huawei modems to never
match and this never be switched to serial mode from mass storage.
The previous implementation traversed the various config directories,
walking the preset files and parsing each line to determine if a service
should be enabled or disabled. It did this for every service which
resulted in many more file operations than neccessary.
This approach parses each of the preset entries into an array which is
then used to check if each service should be enabled or disabled.
networkd: add support to set route table
1. add support to configure the table id.
if id is less than 256 we can fit this in the header of route as
netlink property is a char. But in kernel this proepty is a
unsigned 32. Hence if greater that 256 add this as RTA_TABLE
attribute.
2. we are not setting the address family now. Now set this property.
Introduce
1. sd_rtnl_message_route_set_table to set table ID
2. sd_rtnl_message_route_set_family to set family
Both required to configure route properties.
incapdns.net returns NXDOMAIN for the SOA of the zone itself but is not a
terminal. This is against the specs, but we really should be able to deal with
this.
Previously, when verifying whether an NXDOMAIN response for a SOA/NS lookup is
rightfully unsigned we'd issue a SOA lookup for the parent's domain, to derive
the state from that. If the parent SOA would get an NXDOMAIN, we'd continue
upwards, until we hit a signed top-level domain, which suggests that the domain
actually exists.
With this change whenver we need to authenticate an NXDOMAIN SOA reply, we'll
request the DS RR for the zone first, and use for validation, since that this
must be from the parent's zone, not the incorrect lower zone.
Fixes: #2894
Port the progagation logic to the generic Unit->trigger_notify() callback logic
in the unit vtable, that is called for a unit not only when the triggered unit
of it changes state but also when a job for that unit finishes. This, firstly
allows us to make the code a bit cleaner and more generic, but more
importantly, allows us to notice correctly when a mount job fails, and
propagate that back to autofs client processes.
Fixes: #2181
And let's make it more accurate: if we have acquire the list of unit drop-ins,
then let's do a full comparison against the old list we already have, and if
things differ in any way, we know we have to reload.
This makes sure we detect changes to drop-in directories in more cases.
This fixes fall-out from 6d10d308c6.
Until that commit, do determine whether a daemon reload was required we compare
the mtime of the main unit file we loaded with the mtime of it on disk for
equality, but for drop-ins we only stored the newest mtime of all of them and
then did a "newer-than" comparison. This was brokeni with the above commit,
when all checks where changed to be for equality.
With this change all checks are now done as "newer-than", fixing the drop-in
mtime case. Strictly speaking this will not detect a number of changes that the
code before above commit detected, but given that the mtime is unlikely to go
backwards, and this is just intended to be a helpful hint anyway, this looks OK
in order to keep things simple.
Fixes: #3123
Let's move the enforcement of the per-unit start limit from unit.c into the
type-specific files again. For unit types that know a concept of "result" codes
this allows us to hook up the start limit condition to it with an explicit
result code. Also, this makes sure that the state checks in clal like
service_start() may be done before the start limit is checked, as the start
limit really should be checked last, right before everything has been verified
to be in order.
The generic start limit logic is left in unit.c, but the invocation of it is
moved into the per-type files, in the various xyz_start() functions, so that
they may place the check at the right location.
Note that this change drops the enforcement entirely from device, slice, target
and scope units, since these unit types generally may not fail activation, or
may only be activated a single time. This is also documented now.
Note that restores the "start-limit-hit" result code that existed before
6bf0f408e4 already in the service code. However,
it's not introduced for all units that have a result code concept.
Fixes#3166.
If we remove a directory image (i.e. not a btrfs snapshot) then things might
get quite expensive, hence run this asynchronous in a forked off process, too.
Fall back to a normal copy operation when the backing file system isn't btrfs,
and hence doesn't support cheap snapshotting. Of course, this will be slow, but
given that the execution is asynchronous now, this should be OK.
Fixes: #1308
When recursively copying a directory tree, fix up the file times after having
created all contents in it, so that our changes don't end up altering any of
the directory times.
Let's make sigkill_wait() take a normal pid_t, and add sigkill_waitp() that
takes a pointer (which is useful for usage in _cleanup_), following the usual
logic we have for this.
Cloning an image can be slow, if the image is not on a btrfs subvolume, hence
let's make sure we do this asynchronously in a child process, so that machined
isn't blocked as long as we process the client request.
This adds a new, generic "Operation" object to machined, that is used to track
these kind of background processes.
This is inspired by the MachineOperation object that already exists to make
copy operations asynchronous. A later patch will rework the MachineOperation
logic to use the generic Operation instead.
Torstein Husebø
Lennart Poettering
Franck Bui
Zbigniew Jędrzejewski-Szmek
Lubomir Rintel
Susant Sahani
Alex Crawford
Susant Sahani
Evgeny Vereshchagin
Sylvain Plantefève